path: root/Documentation/devicetree/bindings/reset/st,sti-softreset.txt
diff options
Diffstat (limited to 'Documentation/devicetree/bindings/reset/st,sti-softreset.txt')
1 files changed, 46 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/reset/st,sti-softreset.txt b/Documentation/devicetree/bindings/reset/st,sti-softreset.txt
new file mode 100644
index 000000000000..a8d3d3c25ca2
--- /dev/null
+++ b/Documentation/devicetree/bindings/reset/st,sti-softreset.txt
@@ -0,0 +1,46 @@
+STMicroelectronics STi family Sysconfig Peripheral SoftReset Controller
+This binding describes a reset controller device that is used to enable and
+disable on-chip peripheral controllers such as USB and SATA, using
+"softreset" control bits found in the STi family SoC system configuration
+The actual action taken when softreset is asserted is hardware dependent.
+However, when asserted it may not be possible to access the hardware's
+registers and after an assert/deassert sequence the hardware's previous state
+may no longer be valid.
+Please refer to reset.txt in this directory for common reset
+controller binding usage.
+Required properties:
+- compatible: Should be "st,<chip>-softreset" example:
+ "st,stih415-softreset" or "st,stih416-softreset";
+- #reset-cells: 1, see below
+ softreset: softreset-controller {
+ #reset-cells = <1>;
+ compatible = "st,stih415-softreset";
+ };
+Specifying softreset control of devices
+Device nodes should specify the reset channel required in their "resets"
+property, containing a phandle to the softreset device node and an
+index specifying which channel to use, as described in reset.txt
+ ethernet0{
+ resets = <&softreset STIH415_ETH0_SOFTRESET>;
+ };
+Macro definitions for the supported reset channels can be found in:

Privacy Policy